– 160 –
Chapter 7 Menu Operations — Menu list
Item Description of settings
[SAFETY AREA] Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]…[100%]
f Factory setting: [90%]
[FRAME MARK] Selects frame marker [ON]/[OFF].
[ON], [OFF]
f Factory setting: [OFF]
[FRAME SIG] Sets frame marker aspect ratio.
The [VISTA] is 16:8.65 (1.85:1), and [CNSCO] is 16:6.81 (2.35:1).
[4:3], [13:9], [14:9], [VISTA], [CNSCO]
f Factory setting: [4:3]
[FRAME LVL] Sets the level of the outside of the frame marker.
[0]: Equivalent to signal off (blanking status).
[1]…[14]: Higher numbers indicate increased brightness.
[15]: Same brightness as center.
f Factory setting: [15]
[VF USER BOX]
The user box can be displayed as a box-type cursor in any position.
Item Description of settings
[USER BOX] Sets whether to display the user box in the viewnder.
[ON], [OFF]
f Factory setting: [OFF]
[USER BOX WIDTH] Sets the width of the user box.
[1]…[100]
f Factory setting: [13]
[USER BOX HEIGHT] Sets the height of the user box.
[1]…[100]
f Factory setting: [13]
[USER BOX H POS] Sets the horizontal position of the center of the user box.
[−50]…[50]
f Factory setting: [0]
[USER BOX V POS] Sets the vertical position of the center of the user box.
[−50]…[50]
f Factory setting: [0]
[VF INDICATOR]
Item Description of settings
[EXTENDER] Turns extender display [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[SHUTTER] Turns shutter speed display [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[FILTER] Turns lter no. display [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[WHITE] Turns [AWB PRE]/[A]/[B] display [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[GAIN] Turns the currently selected gain, [S.GAIN], and [DS.GAIN] displays [ON]/[OFF].
[ON], [OFF]
f Factory setting: [ON]
[IRIS] Selects displays of super iris and super black operation status, and iris value.
[IRIS]: Displays only the iris value.
[S+IRIS]: Displays all.
[S]: Displays super iris and super black operation status.
[OFF]: Does not display.
f Factory setting: [S+IRIS]
Coordinates iris value display and iris override display. When iris override is changed, it is displayed for
three seconds even if [OFF] is set.
[CAMERA ID] Sets whether to record camera ID.
[BAR]: Records camera ID when color bar signals are recorded.
[OFF]: Does not record.
f Factory setting: [BAR]
[ID POSITION] Sets the location to display camera ID.
[UPPER R]: Upper right
[UPPER L]: Upper left
[LOWER R]: Lower right
[LOWER L]: Lower left
f Factory setting: [UPPER L]
This item cannot be set when [CAMERA ID] is set to [OFF].
To Next Page
Loading...
