Panasonic AJ-PX800G - Mounting and Adjusting the Lens; Mounting the Lens; Lens Flange Back Adjustment

– 30 –
Chapter 3 Preparation — Mounting and adjusting the lens
Mounting and adjusting the lens
Mounting the lens
Fig. 1
Fig. 4
Fig. 2
Fig. 3
Lens lever
Mount cap
Mark
Cable clamp
<LENS> terminal
1
Raise the lens lever and remove the mount cap. (Fig. 1)
2
Align the indentation at the top center of the lens mount with the center mark of the lens to mount the lens. (Fig. 2)
3
Lower the lens lever to firmly clamp the lens. (Fig. 3)
4
Secure the cable through the cable clamp and connect it to the <LENS> terminal. (Fig. 4)
5
Perform lens flange back adjustments.
For details, refer to “Lens ange back adjustment” (page 30).
@@
NOTE
t For handling the lens, refer to the lens operating instructions.
t For details on the current from the <LENS> terminal, refer to “Details of the connector signals” (page 215).
t When the lens is removed, install the mount cap to protect the device.
Lens ange back adjustment
If images are not clearly focused at both telephoto and wide-angle positions during zoom operations, adjust the lens ange back (distance from the lens
mounting surface to the image formation surface).
Once adjusted, the lens ange back does not need to be readjusted until the lens is changed.
@@
NOTE
t Refer to the lens operating instructions for guidance on adjustment methods and positions of lens parts.