– 22 –
Chapter 2 Description of Parts — Rear side
12 <LEVEL> dial (<INTERCOM>)
Used to adjust the volume level of the intercom when the mixing function of the intercom connected to the <INTERCOM> terminal and the PGM
is enabled. The mixing function of the intercom and the PGM can be enabled/disabled from [MAIN MENU] [INTERCOM SETTING] [INCOM
RECEIVE SETTING] [PGM MIX].
13 <HD SDI1> terminal (BNC)
[CAM]: Outputs camera images.
[HD PROMPT]: Outputs HD prompter video images.
Congure the output images in [MAIN MENU] [IN/OUT SELECT] [HD-SDI1 OUT].
NOTE
Use a cable that is 5C-FB or above.
[HD PROMPT] can be selected only when the camera is connected to the CCU.
Please also note that the video formats available for output are 1080/59.94p/50p/59.94i/50i.
14 <HD SDI2> terminal (BNC)
[CAM]: Outputs camera images.
[VF]: Outputs viewnder images.
[RET]: Outputs return images.
[RET1]/[RET2]: Outputs the selected images.
Congure the output images in [MAIN MENU] [IN/OUT SELECT] [HD-SDI2 OUT].
NOTE
Use a cable that is 5C-FB or above.
[RET] and [RET1]/[RET2] can be selected only when the camera is connected to the CCU.
15 <AUX> terminal
This is the external device connecting terminal.
[PMT OUT]: Outputs prompter video images.
[HD TRUNK]: HD trunk input
Set this from [MAIN MENU] [IN/OUT SELECT] [AUX I/O].
NOTE
Use a cable that is 5C-FB or above.
The video formats available for input to [HD TRUNK] are 1080/59.94p/50p/59.94i/50i.
16 <DC IN> terminal
This is an input terminal for the external DC power supply. Connect an external DC power supply to this terminal. (DC 10.8 V to 17 V)
17 <MIC 2> terminal
Used to connect audio equipment or a microphone.
The power for the microphone is supplied via this terminal, enabling use of a phantom powered (48 V) microphone. Turn the power off when
connecting a microphone, and then congure the settings to suit the microphone after connecting the microphone.
To Next Page
Loading...
