– 48 –
Chapter 4 Menu Operations — Menu list
[INTERCOM SETTING]
[INTERCOM]
Item Description of settings
[INCOM TALK SETTING] [MIC TYPE]
Selects the type of the intercom microphone.
[DYN]: Dynamic type
[ECM]: Condenser type
[CBN]: Carbon type
Factory setting: [DYN]
[MIC POWER]
Sets the on/off for the power supply to the intercom microphone.
[OFF], [ON]
Factory setting: [OFF]
[MIC GAIN]
Sets the volume of the intercom microphone.
[12dB]…[12dB]
Factory setting: [0dB]
[SIDE TONE]
Sets the volume of the intercom microphone side tone.
[OFF], [36dB]…[0dB] (3 dB step)
Factory setting: [6dB]
[LEVEL VR]
Switches intercom level VR.
[REAR], [FRONT]
Factory setting: [REAR]
[PGM MIX]
Sets the on/off for the intercom PGM mix.
[OFF], [ON]
Factory setting: [ON]
[MIC SETTING]
Item Description of settings
[MIC1 (FRONT MIC) GAIN]
Sets the gain when there is a microphone input to the <MIC> terminal (front).
[60dB], [40dB], [20dB]
Factory setting: [60dB]
[MIC1 (FRONT MIC) AMP]
Sets the level of the input to the <MIC> terminal (front).
[20dB]…[20dB]
Factory setting: [0dB]
[MIC2 GAIN]
Sets the gain when there is a microphone input to the <MIC 2> terminal.
[60dB], [40dB], [20dB]
Factory setting: [60dB]
[MIC2 AMP]
Sets the level of the input to the <MIC 2> terminal.
[20dB]…[20dB]
Factory setting: [0dB]
[PAINT]
[COLOR REPRODUCTION]
Item Description of settings
[COLOR TONE]
Sets the color reproduction base.
[NORMAL], [Ver. 0E.0D(0B.0B)], [Ver. 0E.11]
Factory setting: [NORMAL]
[PAINT SWITCH]
Item Description of settings
[BLACK SHADING]
Enables/disables the black shading.
[OFF], [ON]
Factory setting: [ON]
[WHITE SHADING]
Enables/disables the white shading (saw-toothed waveform or parabolic waveform).
[OFF], [ON]
Factory setting: [ON]
[FLARE]
Enables/disables are.
[OFF], [ON]
Factory setting: [ON]
[GAMMA]
Enables/disables gamma.
[OFF], [ON]
Factory setting: [ON]
[BLACK GAMMA]
Enables/disables black gamma.
[OFF], [ON]
Factory setting: [OFF]
[KNEE]
Enables/disables knee.
[OFF], [ON]
Factory setting: [ON]
To Next Page
Loading...
