Panasonic AK-HC3900G - [Network Setup]

– 61 –
Chapter 4 Menu Operations — Menu list
Item Description of settings
[HD-SDI1 3G-SDI]
Sets the output format when [HD-SDI1 OUT] is [CAM] and when the image output from the <HD SDI1>
terminal is 3G output.
[LEVEL-A], [LEVEL-B]
 Factory setting: [LEVEL-B]
NOTE
 This is xed to [LEVEL-A] when [HD-SDI1 OUT] is [HD PROMT].
[HD-SDI2 OUT] Congures the video output from the <HD SDI2> terminal.
[CAM]: Outputs camera images.
[VF]: Outputs viewnder images.
[RET]: Outputs return images.
[RET1], [RET2]: Outputs xed return images.
 Factory setting: [VF]
[HD-SDI2 OUTPUT FORMAT]
Sets the signal format of the video output from the <HD SDI2> terminal.
[1080i], [1080P], [720P]
 Factory setting: [1080i]
[HD-SDI2 OUTPUT ITEM]
Selects details of the characters superimposed on images output from the <HD SDI2> terminal.
[MENU ONLY]: Displays only on the menu.
[STATUS]: Displays all characters that are the same as in the viewnder display.
 Factory setting: [MENU ONLY]
[HD-SDI2 CHAR]
Sets whether to superimpose characters on images output from the <HD SDI2> terminal.
This cannot be set when the output format is [720P].
[OFF], [ON]
 Factory setting: [OFF]
[HD-SDI2 CHAR SIZE]
Sets the size of the characters superimposed on images output from the <HD SDI2> terminal.
[LARGE], [SMALL]
 Factory setting: [SMALL]
[HD-SDI2 3G-SDI]
Sets the output format when [HD-SDI2 OUT] is [CAM] and when the image output from the <HD SDI2>
terminal is 3G output.
[LEVEL-A], [LEVEL-B]
 Factory setting: [LEVEL-B]
NOTE
 This is xed to [LEVEL-A] when [HD-SDI2 OUT] is other than [CAM].
[AUX I/O] Congures the video output from the <AUX> terminal.
[PMT2 OUT], [HD TRUNK]
 Factory setting: [PMT2 OUT]
[T-BAR CONNECT]
Sets whether to connect the T-BAR unit.
[OFF], [ON]
 Factory setting: [OFF]
[LENS I/F]
Sets the lens interface.
[ANALOG], [SERIAL]
 Factory setting: [SERIAL]
[DISPLAY STATUS/BAR
OSD]
[CAM ID CHARACTER]
Sets the camera name.
[NETWORK SETUP]
[NETWORK SETUP] cannot be selected right after the power is turned on, because boot of the camera is in progress.
This is not an error. Perform operation after a while.
Item Description of settings
[IP ADDRESS] Sets the IP address.
 Factory setting: [192.168.0.30]
[SUBNET MASK] Sets the subnet mask.
 Factory setting: [255.255.255.0]
[DEFAULT GATEWAY] Sets the default gateway.
 Factory setting: [192.168.0.1]
[ROP PORT] Sets the port number when connecting to ROP.
[49152], [49200]…[49299]
 Factory setting: [49152]
[SET EXECUTE] Selects whether to execute with the congured settings.
[NO], [YES]
[MAC ADDRESS] Displays the MAC address. (This cannot be changed.)