Press the ENTER button
Press the RIGHT button
The tank set temperature will be displayed.
Use the UP or DOWN button to change the tank set temperature.
Press the ENTER button to lock the new temperature and exit.
How to Change DHW Water Temperature in Cylinder*
To change the hot water set point, please use the following optons:
Maximum Target set temperature for Domestic Hot Water is 5
0
C lower than the maximum flow temperature of heat pump
model installed to be delivered by compressor ONLY, if set higher then direct electric will be used to achieve and incur higher
running cost.
*This option is only available if TANK or HEAT+TANK mode are active
10
To Next Page
Loading...
