Panasonic Aquarea WH-MDF06E3E5 series - Connection to the Compact Unit

7 – 33Aquarea air/water heat pump – Installation manual for compact systems 03 / 2013
7
Electrical installation
Electrical installation
Installing the wired remote control
Connection to the compact unit
1
Remote control cable
2
Chamber front panel
Laying the cable into the device
³ Cut into the cable gland in a cross shape using a knife.
³ Route the cables through the enclosed cable gland on the right side
of the housing to prevent the cables being damaged by sharp edges.
³ Remove the dummy connection from the CN-REMOTE2 connection.
³ Connect the wired remote control cable to the CN-REMOTE2 connec-
tion. Ensure it is attached securely.
³ 6HFXUHWKHFDEOHXVLQJFDEOHWLHVDVVKRZQLQWKHÀJXUH(QVXUHWKDW
the cables cannot come into contact with hot device parts.
2
1
7.3.3 Connection to the compact unit
³ If necessary, open the compact unit as described in Section 5.
1 2
3
4
1
Remote control cable
2
CNREMOTE2 connection
3
Cable ties
4
Cable gland