Panasonic Aquarea WH-SDC16H6E5 - Application Examples

136 Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Planning
5
5.6 Application examples
This section illustrates various application examples for Aquarea air-to-water heat pumps.
!
IMPORTANT
The gures used are purely schematic representations showing the principal components and
can be used as the basis for designing concrete systems. They do not, however, include all the
components needed according to EN 12828 nor all necessary safety devices.
Please follow all the relevant standards and guidelines while designing concrete systems.
The following application examples only relate to the current bi-bloc systems of the J or
H generation with hydrokit or with All in One unit in standard or two-zone conguration (“B”)
(→4.6.2.1Components(bi-blocsystems),p.29).
The hydraulic schematics were created with the Hydraulic Scheme Generator. Based on
the installation requirements entered, this online tool creates an exact hydraulic schematic
to facilitate the proper connection of the heat pumps. Panasonic provides it free of cost at
www.PanasonicProClub.com.
You will nd a detailed legend for all the hydraulic schematics subsequent to the graphic
representations (→5.6.9Keyfortheapplicationexamples,p.145).
Details about the settings on the remote controller for the various application examples are given in
the operating instructions for the respective device.
i
Note
You will nd information about application examples with bi-bloc systems of earlier generations in
the Planning Manual of 2014.