28 Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Product Description
4
Easy operation
● Contol panel for standard and All in One bi-bloc systems is integrated in the hydrokit,
but can be installed separately within the building in the same way as the control panel
for mono-bloc systems
● Easy programming via the control panel
● For safety reasons, the hydrokits, All in One units and mono-bloc units are all tted
with a residual current circuit breaker (RCCB).
Easy Maintenance and Assembly
● Compact design
● Easy control of the water pressure by using the hydraulic gauge in the front panel of
the hydrokit or All in One unit
● All units are easy to open for optimum accessibility of all internal parts
● All in One units with factory-tted pipe connections are easy to install
● Flexible installation possibilites due to long pipe runs
● Pipe runs of up to 30 metres with a height dierence up to 20 metres possible
(depending on model)
● Pipe connections to the outdoor units can be made in four directions (front, rear, side,
below)
● Mono-bloc systems are particularly easy to install, because there are no refrigerant
connections to be made
4.6.2 Bi-bloc system
The Aquarea bi-bloc system consists of an indoor unit (which can be a hydrokit or an All in One
unit) and an outdoor unit. Both units of the bi-bloc system are congured such that they are
mutually matched to one another as a kit, i.e. the outdoor units cannot be combined arbitrarily
with the dierent indoor units. A suitable Aquarea bi-bloc system kit is available for all typical
applications.
13.04.2021, cH
Following table with operating limits deleted, be-
cause it has become a bit fuzzy (too many dier-
ent conditions for too many dierent generations
and model types); it is easier to look it up in the
technical data tables. OK?
To Next Page
Loading...
