153
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Installation
6
Hydrokit J or H generation
55
200
756
1556
07 061
> 375 > 375
1 2 3
45
1
1 Wall
2 Top mounting plate
3 Hexagon screw M8 with washer
4 Hydrokit
5 Bottom mounting plate
6 Hooks
7 Slots
8 Phillips head screw
1
2
6
5
7
5
8
6.4.2 Outdoor units and mono-bloc units
Carry out the following steps to install the outdoor unit or mono-bloc unit:
1. Exercise caution when unpacking the device at the installation site.
2. Attach the device to a concrete foundation or a strong ground frame by means of four anchor
bolts as shown in the illustration (see below) e.g. on the outer wall of a building. Ensure
horizontal alignment of the device. Also observe the instructions in the sections on attaching
the devices (→ 5.2.2.3 Securing the outdoor unit, p. 102, → 5.2.3.3 Securing the mono-bloc
unit, p. 111).
To Next Page
Loading...
