Panasonic Aquarea WH-SXC09H3E5 - Hydrokits

156 Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Installation
6
2
3
1
 Note:Schematicgureforexplanationpurposesonly.
6.5.2 Hydrokits
Removing and replacing the front plate
Carry out the following steps to remove the front plate:
1. Remove the xing screws (1) on the front plate.
2. Exercise caution as you pull out the bottom part of the front plate towards you to release the
front plate from the left and right hooks (2).
3. Lift up the front plate with both hands and remove it from the hooks (3).
4. To replace the front plate, proceed in the reverse order. See that the right and left hook
engage correctly.
Hydrokit J and H generation
1
2
3
Two screws at the bottom edge of the front plate
Opening and reclosing the connection box
Carry out the following steps to open the cover of the connection box for the hydrokit of the J or
H generation:
1. Remove the front plate as described earlier.
2. Remove the six xing screws (2) on the cover of the connection box (1).
3. Swing the cover to the right (3).
4. To close the cover of the connection box, proceed in the reverse order.