174 Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Installation
6
1
1 Safety valve drainage tap
Hydrokit J or H Generation
Carry out the following steps to connect the drain hose to the safety valve drainage tap of the
hydrokit:
1. Slide the drain hose onto the safety valve drainage tap on the hydrokit.
2. Ensure that the drain hose is seated rmly. Use a hose clip to attach the hose, if necessary
(to be eld-supplied).
3. Lay the drain hose with a constant slope into a suitable receptacle for the condensed water
(to be eld-supplied).
Detail view from below
1
1 Safety valve drainage tap
To Next Page
Loading...
