104
NTP
Settings relating to the NTP server address and port No. are performed.
This item’s setting is reflected when the [Set] button is pressed.
Synchronization with NTP
[Off, On]
Set whether to use an NTP server by selecting “On” or “Off”.
Setting value:
On Uses an NTP server. (Synchronizes the date and time with the NTP server.)
Off Does not use an NTP server.
Factory settings: Off
NTP server address setting
[Auto, Manual]
Select the method to acquire the NTP server address.
Setting value:
Auto Acquires the NTP server address from the DHCP server.
Manual Sets the address by inputting the NTP server address in [NTP server address].
Factory settings: Manual
[Note]
To acquire the NTP server address from the DHCP server, you need to set “DHCP” (page 99) of “IPv4 network”
on the [Network] tab of the network setup screen [Network] to “On”.
To Next Page
Loading...
