Panasonic AW-HE20KP - Wireless ID; OSD off with Tally; Color Bar

60
Status Lamp
[Enable, Disable]
[Disable] or [Enable] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit
is in operation, set to [Disable].
Factory settings: Enable
[Note]
Even when set to [Disable], the status display lamp may light up
when this unit is starting up, updating firmware, or trouble is
occurring.
Wireless ID
[1, 2, 3, 4]
Configure the unit’s remote control ID. The settings for this item
correspond to the [CAMERA 1] to [CAMERA 4] buttons on the
wireless remote control.
Factory settings: 1
OSD off with Tally
[Off, On]
“Off” or “On” the function that turns off menu and other displays
when red tally signals are received via commands.
When the red tally signal releases, the menu display will return.
Factory settings: Off
Color Bar
[Off, On]
Switch between color bar display and camera image display.
Color Bar
Factory settings: Off
[Note]
Only HDMI and SDI can output color bar.
IP and USB cannot output color bar.