99
Network Settings
Configure Network, RTMP, and NTP setting in the Network setup screen.
Click [Setup] > [Network].
Network
Setup IPv4 and IPv6 network.
Click [Setup] > [Network] > [Network].
IPv4 network
Click [Set] button to save the configuration.
DHCP
[Off, On]
Select the method in which the IP address is configured.
Factory settings: off.
IP Address
Input the unit’s IP address here when the DHCP function is not going to be used. Input an address that will not
duplicate an existing IP address which has been set for a personal computer or another network camera.
Factory settings: 192.168.0.10
[Note]
Multiple IP addresses cannot be used even when the DHCP function is used. For details on the DHCP server
settings, consult your network administrator.
Subnet Mask
Input the unit’s subnet mask here if the DHCP function is not going to be used.
Factory settings: 255.255.255.0.
To Next Page
Loading...
