89
Power off the Camera Unit
When performing the operations using the wireless remote control
1.
Press one of the CAMERA<1> to CAMERA<4> buttons on the wireless remote control to
select the unit.
2.
Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The unit enters STANDBY mode.
3.
The unit’s status display lamp now lights up orange.
4.
If a multiple number of units are used, repeat steps 1 and 2 as required.
5.
Set all the power switches of the units and devices connected in the system to OFF.
When performing the operations using the controller (AW-RP60, AW-RP150).
For details, refer to the operating instructions for the controller.
To Next Page
Loading...
