105
NTP server address
When [Manual] is selected in the [NTP server address setting], input the IP address or host name of the NTP server.
Maximum number of characters 0 to 128 half-size characters
Characters that can be entered
Half-size alphanumeric characters, half-size symbols :. _ -
Factory settings: blank
[Note]
To input the [NTP server address] host name, the [DNS] setting must be selected on the [Network] tab of the
network setup screen [Network] (page 100).
NTP port
Input the port No. of the NTP server.
Port Nos. that can be selected: 1 to 65535
Factory settings: 123
Time adjustment interval
Selects the interval (1 to 24 hours in 1-hour increments) for acquiring the time from the NTP server.
Setting range: 1h to 24h
Factory settings: 1h
To Next Page
Loading...
