Panasonic AW-HE20WP - Parts and Functions

21
Parts and Functions
1
2 3
4
1. Lens
2. Tally status indicator
- Red light: The unit is receiving tally command.
- Red light flashing once (1Hz): The unit’s pan/tilt limit
is being configured.
- Red light flashing twice (1Hz): The unit’s pan/tilt limit
is being cancelled.
- Blue light: USB Video Class/Audio Class is in
operation.
3. Camera head
4. Power status indicator
- Orange light: Standby mode
- Green light: The unit is turned on
- Flashing green light (1Hz): The unit is receiving a
wireless remote control signal with a matching
remote control ID
- Flashing(1Hz) orange light: The unit is receiving a
wireless remote control signal with a different
remote control ID
- Flashing (5Hz) green light: After Initialization 1 and
Initialization 2 via DipSW
- High speed (5Hz) flashing orange light: When a
signal from the wireless remote
control is received while the wireless control is set to
“Disable” from the web screen menu.
- Flash (1Hz) red light: Firmware updating
- Red light: Firmware update failure or other
abnormality.
5. LAN indicator(LINK/ACT)
Lights up when data is transmitted/received via LAN.
6. LAN connector
Use a category 5e or above LAN cable with a
maximum length of 100 m (328 ft.)
[Note]:
Use of an STP (shielded twisted pair) cable is
recommended.