Panasonic AW-HE20WP - Page 93

93
Preset scope
[Mode A, Mode B, Mode C]
Selected here are the setting items to be recalled when the contents of the preset memory are regenerated.
Mode A Pan, Tilt, Zoom (including digital zoom), Focus, Iris, Gain, white balance adjustment value
Mode B Pan, Tilt, Zoom (including digital zoom), Focus, Iris
Mode C
Pan, Tilt, Zoom (including digital zoom), Focus
[Note]
 When registering a preset position, all values are saved.
 When recalling a registered preset position, there are certain operation procedures to undergo beforehand so
that each value can come into effect:
[Focus]
Firstly, enable manual focus. Then, the focus value of the recalled preset position can come into effect.
[Iris]
Firstly, enable manual iris. Then, the iris value of the recalled preset position can come into effect.
[Gain]
Firstly, set Gain between 0 dB～42 dB. Then, the Gain value of the recalled preset position can come into
effect.
[White Balance Mode]
Firstly, set White Balance Mode as AWB A or AWB B. Then, the White Balance Mode value of the recalled
preset position can come into effect.
Factory settings: Mode A
Zoom Mode
[Opt.Zoom, i.Zoom, D.Zoom]
Configure the maximum zoom magnification.
Opt.Zoom
Use only the optical zoom. Up to 12× optical zoom is possible.
i.Zoom Enabling this function allows you to perform electronic zoom while reducing drops in picture
quality.
Combining optical zoom and electronic zoom, up to 15.96× zoom is possible.
D.Zoom Enable the digital zoom function.
Picture quality degrades as zoom increases with digital zoom.
Factory settings: Opt.Zoom
Max Digital Zoom
[×2, ×3, ×4]
Set the maximum digital zoom magnification. This is only enabled when [Zoom Mode] is set to [D.Zoom].
[Note]
Higher digital zoom magnifications will result in coarser images.
Factory settings: ×4
Digital Extender
[Off, ×1.4, ×2.0]
Make settings for the digital extender function.
Off
Turn the digital extender function off.
×1.4
The digital zoom will be fixed at 1.4×.
×
2.0
The digital zoom will be fixed at 2.0×.
This is only enabled when [Zoom Mode] is set to [Opt.Zoom].
Factory settings: Off