95
Status lamp
[Enable, Disable]
[Disable] or [Enable] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit is in operation, set to [Disable].
Factory settings: Enable
[Note]
Even when set to [Disable], the status display lamp may light up when this unit is starting up, updating firmware, or
trouble is occurring.
OSD off with Tally
[Off, On]
This is used to enable or disable the function for clearing the OSD menu displays when the tally signal is received
by a command or contact.
When the tally signal is released, the original OSD menu displays are restored.
Colorbar
[Off, On]
Switch between camera images and color bars.
When the color bars are displayed, a test tone is output according to the Audio setting in the camera menu.
Factory settings: Off
Wireless ID
[1, 2, 3, 4]
Configure the unit’s remote control ID. The settings for this item correspond to the [CAMERA 1] to [CAMERA 4]
buttons on the wireless remote control.
Value: 1, 2, 3, 4
Wireless Control
[Off, On]
Switch the power ON/OFF control with the wireless remote control.
USB Video H.264
[Enable, Disable]
Switch the “Enable” or “Disable” of USB Video H.264.
[Note]
Using the USB Video with Skype for Business, set the USB Video H.264 to "Disable".
Factory settings: Disable
To Next Page
Loading...
