Installation Instructions
Before installation
Be sure to configure the switches on the connector panel and bottom of
the unit before installing it.
Configuring the switches after the unit is installed may prove difficult.
Service switch settings
The service switches are located on the connector panel of the unit.
Perform switch settings before turning the unit on.
LAN
LINK
ACT
SIGNAL
GND
12 V IN
G/L IN
1 2/PM
3G SDI OUT
SFP+ 12G SDI OUT
USB3.0 HOST
RS-422
SERVICE
1 - AUDIO INPUT - 2
SW1
ON
OFF
SW2 SW3 SW4
Service switch
Function Factory settings
SW1
Switches for initializing and initial settings
(Refer to the explanations in “Initialization 1”,
“Initialization 2”, “Direct start mode”)
OFF
SW2 OFF
SW3 OFF
SW4 OFF
Initialization 1
• Reset the user authentication settings and host authentication settings
for network connection.
(This will delete all the registered user information (IDs/passwords)
and host information (IP addresses).)
• With the service switches set as shown below, turn on the power of
the unit.
SW1
ON
OFF
SW2 SW3 SW4
<NOTE>
When initialization is complete, the status display lamp on the front of
the unit blinks green. Set the service switches back to their original
positions (SW1 to SW4 all OFF), then restart the unit.
Initialization 2
• The unit is reset to the state it was in at the time of purchase. (All
camera menu setting values and network setting values are reset.)
• With the service switches set as shown below, turn on the power of
the unit.
SW1
ON
OFF
SW2 SW3 SW4
<NOTE>
• When initialization is complete, the status display lamp on the front
of the unit blinks green. Set the service switches back to their original
positions (SW1 to SW4 all OFF), then restart the unit.
Direct start mode
• When the power of the unit is turned on, the pan‑tilt head (tilt) is not
returned to horizontal as part of the lens initializing operation. Use
when the tilt cannot be returned to horizontal, such as when the unit is
installed in a tight space.
ON
<NOTE>
• This may result in a slight change in tracking performance.
Setting the installation method (“DESKTOP” or
“HANGING”) from the OSD menu
Set [DESKTOP] or [HANGING] in [PAN/TILT] – [INSTALL POSITION]
from the OSD menu of this unit.
INSTALL POSITION [DESKTOP, HANGING]
[DESKTOP] or [HANGING] is selected here as the method used to
install the unit.
DESKTOP Stand-alone installation
HANGING Suspended installation
<NOTE>
• When [HANGING] has been selected, the top, bottom, left and right
of the images will be reversed, and up/down/left/right control for
panning and tilting will also be reversed.
Setting the wireless remote control ID
Set [CAM1] to [CAM4] in [MAINTENANCE] – [WIRELESS CONTROL] –
[WIRELESS ID] from the OSD menu of this unit.
WIRELESS ID [CAM1, CAM2, CAM3, CAM4]
Set the remote control ID (CAM1 to CAM4).
The “CAM1” to “CAM4” in this setting correspond to the CAMERA <1> to
<4> buttons on the wireless remote control.
(The factory setting is “CAM1”.)
SET
MODE
ON
ー
OPT
ー
OFF
OFF
LOW
HI
AUTO
MENU
CAMERA
GAIN
1 2 3 4
1
4
7
10 11 12
8 9
5 6
2 3
PRESET MEMORY
PRESET
HOME
CAMERA <1> to <4> buttons
6 7
To Next Page
Loading...
