Panasonic AW-UE20KP - Serial Communication Settings; Baud Rate and Camera Address

62
Baud Rate
[9600bps, 38400bps]
You can select a baud
rate for serial communication.
Factory settings: 9600bps
This is only enabled when [Serial Com. Protocol] is set to
[Standard].
Camera Address
[Auto, 1, 2, 3, 4, 5, 6, 7]
Should you select Auto, the unit wil
l be assigned with an IP
address based on the order you connected the unit. If you
select any number from 1 to 7, it will be assigned to the
specified camera number.
Factory settings: Auto
This is only enabled when [Serial Com. Protocol] is set to
[Standard] and [Connector Select] is set to [RS232C].