50
Switching between Live and Setup Screen
When the live screen is displayed, click the [Setup] button.
For details on the web setup screen, see “Web Screen Configuration” section.
When the web setup screen is displayed, click the [Live] button to switch to live screen.
For details on the live screen, see “Web Live Screen Operation” section.
[Note]
During Standby mode, the [Setup] button is disabled, and you cannot switch to the [Setup] screen.
If the unit is switched to Standby mode from another terminal while the [Setup] screen is displayed, the display will
switch to the live screen after a few seconds.
To Next Page
Loading...
