Network setup screen [Network]
Configure network settings in the Network setup screen.
The Network setup screen [Network] consists of [Network] and
[Advanced].
Network setup screen [Network]
Click the [Network] of the Network setup screen [Network].
The setting is confirmed with the [Set] button.
The following information is required to configure network settings.
Consult your network administrator or Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using a gateway server or router)
• HTTP port
• DNS primary and secondary server addresses (when using DNS)
z Add host
IP address
The IP address of the personal computer from which access to the
camera is allowed is input here. The host name cannot be input as
the IP address.
<NOTE>
• When the “IP address/subnet mask length” is input, the personal
computers which are allowed to access the camera can be
restricted on a subnet by subnet basis.
If, for instance, “192.168.0.1/24” has been input and the [2. Camera
control] setting has been selected as the [Access level] setting, the
personal computers from “192.168.0.1” to “192.168.0.254” will be
able to access the camera at the [2. Camera control] access level.
• When an already registered IP address is input and the [Set] button
is clicked, the host information will be overwritten.
Access level [1.Administrator, 2.Camera control]
Select the host access level.
The setting is confirmed with the [Set] button.
1.Administrator This access level allows the user to perform all the
unit’s operations.
2.Camera control This access level allows you to display images and
control the unit. The unit cannot be set.
Factory settings: 2.Camera control
z Delete host
Delete the host information registered in the unit.
You can delete selected host information by clicking the [Delete] button
at the right.
110
Web screen configurations (continued)
To Next Page
Loading...
