Stream ID
When [Client(Caller)] is set in [Mode], enter the Stream ID.
The information entered is notified to the connection destination when
SRT transmission is started.
If the [InsertTemplate] button is clicked, the following template is
inserted in the input fields.
#!::m=publish,r=PanasonicStream
• The following characters can be displayed.
Numeric characters 0123456789
Alphabetical
characters
(upper and lower
cases)
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
Symbols
!”#$%’()=-~^¦\`@[]{}
*
:+;<>,.?/\_
Factory settings: #!::m=publish,r=PanasonicStream
Client(Caller) port [1 to 65535]
When [Listener] is set in [Mode], enter the port number (used when
this unit is waiting for a connection).
The following port numbers are used by the unit so they cannot be
used.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 546,
547, 554, 995, 5960 to 5985, 7960 to 8060, 10669, 10670, 11900,
59000 to 61000
Factory settings: 2020
TTL/HOP Limit
The same as H.264 Multicast TTL/HOPLimit (→ page 92).
<NOTE>
• When streaming SRT via a public network, it is recommended to
change the TTL setting to a suitable value (64, etc.).
Latency
Sets the time between when images and audio are sent and when
they are played on the receiving device in a range between 0 and
99999 (ms).
Factory settings: 120
<NOTE>
• In some cases, the set time is not guaranteed depending on the
network band.
Encryption [Off, AES-128, AES-256]
Sets whether to encrypt the transmitted IP image.
Off Transmits unencrypted IP images.
AES-128 Encrypts IP images in AES-128 before transmitting.
AES-256 Encrypts IP images in AES-256 before transmitting.
Factory settings: Off
• The following characters can be displayed.
Numeric characters 0123456789
Alphabetical
characters
(upper and lower
cases)
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
Symbols _-
Passphrase
Sets the phrase used for decoding the encrypted IP images.
(10 to 24 characters)
Streaming format
Makes settings for H.264 or H.265 images for use in SRT
transmission.
The setting is confirmed with the [Set] button.
Refer to the explanation for H.264 (→ page 91) or H.265
(→ page 93) for information about Image capture size, Frame rate
and Max bit rate(per client).
<NOTE>
• Streaming format settings cannot be changed during SRT
transmissions.
• When the frame frequency is 24/23.98Hz, you cannot set to the
SRT(H.264), or SRT(H.265) modes.
z MPEG2‑TS over UDP
Make settings for MPEG2-TS over UDP transmission.
<NOTE>
• In order to receive the images being transmitted by the camera, enter
the following URL in the application or service.
- For Unicast
udp://@[unicast ipaddress]:[unicast port]
- For Multicast
udp://@[multicast ipaddress]:[multicast port]
Transmission type [Unicast, Multicast]
Sets the transmission type for MPEG2-TS over UDP transmission as
either Unicast or Multicast.
Factory settings: Unicast
94 95
Web screen configurations (continued)
To Next Page
Loading...
