Unicast address(IPv4)
Sets the Unicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 192.168.0.3
Unicast Port [1024 to 50000]
Sets the Unicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 7002
Multicast address(IPv4)
Sets the Multicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 239.192.0.20
Multicast Port [1024 to 50000]
Sets the Multicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 32004
Multicast TTL/HOPLimit
The same as H.264 Multicast TTL/HOPLimit (→ page 92).
Push UDP [Enable, Disable]
When Push UDP has been set to Enable, MPEG2-TS over UDP
transmission starts automatically when the camera is started.
Factory settings: Enable
Streaming format
Make settings for H.264 images used for MPEG2-TS over UDP
transmission.
The setting is confirmed with the [Set] button.
Refer to the description of H.264 (→ page 91) for information about
Image capture size, Frame rate, and Max bit rate(per client).
<NOTE>
• Streaming format settings cannot be changed during MPEG2-TS
over UDP transmissions.
z NDI|HX V2
Make NDI|HX V2 transmission settings.
The setting is confirmed with the [Set] button.
NDI|HX V2
<NOTE>
• This unit restarts when [Streaming mode] is changed to [NDI|HX
V2], or when changed from [NDI|HX V2] to another mode.
Source name
Sets the device name displayed when this unit is detected by software
applications and hardware compatible with NDI|HX.
Factory settings: NDI_Device-[serial number of this unit]
Maximum number
of characters
1 to 32 characters
Characters that
can be entered
Alphanumeric characters, symbols: - _
Protocol [TCP, UDP]
Sets the format of unicast transmission to be used.
Factory settings: TCP
Multicast Transmit [On, Off]
Sets whether to perform multicast transmissions of images for
software applications and hardware that are compatible with NDI.
Factory settings: Off
Address(IPv4) [IPv4 : 244.0.0.0 to 239.255.255.255]
Enter he multicast IP address.
Images and audio are transmitted to the specified multicast address.
Factory settings: 239.192.0.30
<NOTE>
• Check the multicast IP addresses available for use before
entering.
96
Web screen configurations (continued)
To Next Page
Loading...
