Panasonic AWRP120 - Registering the Unit in Setup Software

47
Setup Software (continued)
The screens of Windows XP are used in the explanations in this manual
If you are using an operating system other than Windows XP, some of the items displayed on the screens may differ
Registering the unit in Setup Software
On the “IP Address” tab, register the IP addresses of units to be set from Setup Software
The units registered here can be selected from the list box on the “Setting” tab
Up to five units can be registered
1 Enter the IP addresses in the IP ADDRESS boxes
In the RP1 to RP5 boxes, enter the IP addresses of the AW‑RP120
to register
2 Click [Set] button
3 In the list box on the “Setting” tab, select the AW‑RP120
whose data is to be referenced
The settings configured on the selected unit are displayed on the
“Setting” tab