40
BL-C111A /BL-C131A
9 Disassembly and Assembly Instructions
MAC address label caution
hen you replace the main board, you must also attach the new MAC address label(included with the main board). Attach the
new MAC address label to the unit by placing over the old MAC address label. Make sure the old address cannot be seen.
Throw away the old main board. It cannot be reused.
(If the MACaddress of the old main board is already registered via DDNS and thenused in a different camera, the camera can-
not be used with DDNS service.)
9.1. Disassembly Instructions(BL-C111A)
9.1.1. How To Remove Main Board and I/O Board
1. Remove two Screws (A). And remove the Cabinet Cover.
2. Remove three Cable.
3. Remove three Screws (B).
4. Remove Main Board and I/O Board from Cabinet Body.
To Next Page
Loading...
