Panasonic BT-LH2170 - Zebra and Y Map Functions; Zebra Pattern Adjustment; Y Map Brightness Confirmation

40
Main Menu (continued)
41
 ZEBRA
The stripes of the ZEBRA function appear over an image (in the viewfinder) to help you adjust the aperture of a camera lens for
optimum exposure and easily find the areas of an image that are overexposed and turn white (where clipping occurs).
Press any of the <FUNCTION1> to <FUNCTION5> (→page 12) buttons to which [ZEBRA LEVEL] is assigned or select [ZEBRA] in
the [VIDEO CONFIG] menu to set [INT.MIN.], [INT.MAX.], [EXT.MIN.] and [EXT.MAX] levels.
Press the <FUNCTION1> to <FUNCTION5> button to which the [ZEBRA] function has been assigned to turn the ZEBRA function
on.
[INT.MIN.] and [INT.MAX.] show ZEBRA stripes for areas that are within menu set values.
[EXT.MIN.] and [EXT.MAX.] show ZEBRA stripes for areas that are outside menu set values.
[INT.MIN.] and [INT.MAX.] ZEBRA
pattern
[EXT.MIN.] and [EXT.MAX.] ZEBRA
pattern
 Y MAP
The Y MAP function makes it easy to visually confirm overall screen brightness (luminance level map).
Press the <FUNCTION1> to <FUNCTION5> (→page 12) button to which the [Y MAP] function has been assigned to turn it on.
Turning on this function displays a simplified chart at the left side of the screen.
• Simplified chart details (The numbers in the simplified chart indicates Y signal levels.)
100%
>100%
75%
50%
25%
0%
Red
DarkOrange
Orange
Yellow
LightGray
Gray
DarkGray
Blue
DarkBlue
Magenta
100%
<0%
95%
85%
75%
60%
40%
20%
10%
0%
<Note>
• When [HALF] or [BLACK] is selected in [BACK] under the [MARKER] menu, the simplified chart indicates a signal level of 50 % or
may not be displayed at all.
• When the Y MAP function is on, [BLACK MODE] is turned off.