Panasonic BT-LH910G - VF Function

16
VF Function
The unit can be connected to broadcasting and business cameras made by Panasonic and used as a VF (viewfinder).
If you want to use the unit as a VF (viewfinder), remove the tilt stand (page 17).
Camera platform
*
1
(commercially available)
VF cable (Option)
Part number: BT-CS910G
Camera side VF terminal
VF connector on unit side
Use a camera platform that can fully withstand the weight of the unit (1.7 kg (3.75 lb)).
*
1
<Note>
This unit requires a current that exceeds the output rating of a Panasonic camera-recorder, so the external
DC power cannot be supplied from the DC output terminal of a Panasonic camera-recorder.
Do not use the battery pack. If this unit is mounted on the camera-recorder with the battery pack attached,
the camera platform may be damaged. Use an external DC power supply.
Contact your vendor for details of broadcasting and business camera-recorders that will be launched in the
future.
Panasonic camera-recorders that allow the unit to be connected as a VF( viewfinder)
■
Panasonic Camera-
recorder
VF Video
Signals
*
1
VF Communication
Monitor
→ Camera
Camera → Monitor
*
2
YP
B
P
R
VIDEO ZEBRA
*
3
TALLY Indication of
Abnormal
Operating State
Changing of
Aspect (SD
Mode Only)
RED
*
4
GREEN
AJ-HPX3100G
     
AJ-HPX3700G
   
AJ-HPX2700G
    
AJ-HPX2000/2100
     
AJ-HDX900
    
AG-HPX500/502
(Monochrome images
of SD resolution)
    
Configure the menu settings in accordance with the output signal format of the camera (page 48).
*
1
For the settings, refer to the instruction manual of the camera.
*
2
The ZEBRA information can be set for the camera (page 37).
*
3
The tally lamp on the rear of the monitor lights in accordance with the REAR TALLY setting (page 37).
*
4