Main Menu
(continued)
2D/3D ASSIST
The underlined values are factory preset setting values.
Setting Description
2D
3D ASSIST
Switches between 2D mode and 3D assist mode.
<2D> Operates in 2D mode.
<3D ASSIST> Operates in 3D assist mode.
If you switch to 3D assist mode, the channel setting is forcefully
switched to SDI1 (SDI2).
Use knob 4 to switch between each of the assist functions. (page
52)
MARKER
The underlined values are factory preset setting values.
Sub menu Settings Description
MARKER
OFF
*
1
ON
Enables the MARKER setting.
16:9
*
2
*
3
OFF
4:3
13:9
14:9
CNSCO 2.39
CNSCO 2.35
2:1
VISTA
95%
93%
90%
88%
80%
USER 85%
Selects/displays the marker type for when the angle of view of
the displayed image is 16:9.
<OFF> No marker display
<4:3> 4:3 marker
<13:9> 13:9 marker
<14:9> 14:9 marker
<CNSCO 2.39> 2.39:1 marker
<CNSCO 2.35> 2.35:1 marker
<2:1> 2:1 marker
<VISTA> VISTA marker
<95%> 95 % area marker
<90%> 90 % area marker
<80%> 80 % area marker
<93%> 93.1 % area marker (TYPE1)
93 % area marker (TYPE2)
<88%> 89.5 % area marker (TYPE1)
88 % area marker (TYPE2)
<USER> Area marker that is adjustable in 1 % increments within
a range of 80 % to 100 %. However, when MARKER
TYPE is TYPE1, 88 % becomes the aspect ratio of the
vertical 89 %.
(The factory preset setting value is 85 %.)
(Continued on next page)
This setting is turned “ON” when receiving marker control in REMOTE operation. (GPI, if set, has
*
1
priority.)
These settings are disabled when the GPI function (page 62) is used to control the marker setting.
*
2
These settings are enabled when the SD aspect setting for an HD signal and SD signal is 16:9 ( “SD
*
3
ASPECT” on page 31).
To Next Page
Loading...
