Panasonic BT-S1315DA - Removal of A-P.C.board

file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0206000000.html
2.6 Removal of A-P.C.Board
TOP PREVIOUS NEXT
1. Remove the top cabinet according to the section 2.2. "Removal of Top Cabinet".
2. Remove the rear cover according to the section 2.3. "Removal of Rear Cover".
3. Disconnect the wires connected from other components to A- and B-P.C.Boards.
4. Slide the plastic chassis block backward while lifting its rear edge.
5. Unscrew screw [A] fixing the ground lug.
6. Loosen the screw fixing W-P.C.Board. ([B] portion)
7. For BT-S1315DAD/S1415DAD, unscrew 2 screws [C] fixing the SDI pack.
8. Disconnect the wires connected from B- and W-P.C.Boards to A-P.C.Board.
9. Disconnect the connectors between B-P.C.Board and/A-P.C.Board, then remove the B- and W-
P.C.Boards block.
10. Unscrew the screw [D] fixing the fly-back transformer.
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0206000000.html (1 z 2) [2006-02-04 08:28:22]