Panasonic BT-S1315DA - Adjustment Procedure

To Next Page

To Previous Page

file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0411030000.html

4.11.3 Adjustment Procedure

TOP PREVIOUS NEXT

1. Input an NTSC crosshatch pattern signal and check that the black level is 140 V±5 V at TPY4

(GK).

2. Set the monitor to the FACTORY mode, then select PICTURE REF from the menu, and then

adjust CONTRAST on the PICTURE REF menu to obtain B=60.0 V±1.0 V.

3. Input an RGB crosshatch pattern signal.

4. Adjust RGB-CONTRAST on the PICTURE REF menu to obtain B=60.0 V±1.0 V.

•@

TOP PREVIOUS NEXT