Panasonic CF-28 Series - Page 31

Microphone Jack
Use only a monaural condenser
microphone.
Using an input source other
than a monaural condenser mi¬
crophone may not allow audio
to be input or may damage the
equipment.
The settings for [Internal MIC]
of the [Main] menu in the
Setup Utility apply to both the
Internal Microphone and the
Microphone Jack.
i External Keyboard/Mouse Port 0(^)
USB Port -
“USB Device”)
NOTE
Expansion Bus Connector
“Port Replicator”)
- Headphone Jack Q
Use this connector to connect headphones or ampli¬
fier-equipped speakers. Audio output from the inter¬
nal speaker is disabled when headphones or external
speakers are connected.
When using a microphone (internal or external), do not remove the check mark for “Mute” under
“Microphone Balance” of the Volume Control dialog box and do not increase the playback volume.
Howling may result. Howling may occur in the same way when disconnecting an external micro¬
phone. (The microphone of “Volume Control" is in the state of mute at the time of factory shipment.
This is not shown at the time of factory shipment.)
Hard Disk Drive -
“Hard Disk Drive”)
Battery Pack
“Battery Power”)
O ^
(Figure illustrating when the covers have
^ been removed.)
-<Attaching the strap>-
— : .. ^
} • The strap has been designed to carry only the |
j weight of the computer. Therefore, be sure that the I
j strap does not carry a weight that exceeds the I
1 weight of the computer. The strap may acciden- <
i tally come loose from the computer. I
1 • Do not use a strap that is damaged or about to tear. ]
31
Appendix