38
Security Measures
Setting the Hard Disk Lock (enabling, disabling)
1 Run the Setup Utility. ( page 87)
2 Using either or , select [Security].
3 Using either or , select [Hard Disk Lock] and press
Enter
.
4 Select [Enable] or [Disable].
To enable the Hard Disk Lock
Select [Enable] and press
Enter
. At [Caution], press
Enter
.
To disable the Hard Disk Lock
Select [Disable] and press
Enter
.
5 Press
F10
and select [Yes], then press
Enter
.
CAUTION
To change your hard disk drive
• Contact Panasonic Technical Support.
• Before changing the hard disk, be sure to set the [Hard Disk Lock] to [Disable].
Disabling the floppy disk operation makes it impossible to read and write a floppy disk and to
start the computer from a floppy disk. This can prevent data from being accessed illegally or
overwritten accidentally using a floppy disk.
NOTE
It is not possible to disable a USB floppy disk drive.
Preventing theft or damage to data using a disk
To Next Page
Loading...
