Panasonic CF-29 Series - Page 83

83
Wireless LAN
 Enable/Disable 802.11a
1 Select the wireless LAN Switch ( or ) on the taskbar.
2 To enable 802.11a:
A Click [Enable 802.11a].
To disable 802.11a:
A Click [Disable 802.11a].
 To use 802.11a, turn the wireless LAN on.
 If 802.11a is enabled or disabled while the computer is connected to an
802.11b/g access point, the connection to the access point will be temporarily
interrupted.
 You can change the setting of the wireless LAN standard ([Wireless Mode]) in
[Device Manager] using the following procedure:
A Select [start] - [Control Panel] - [Performance and Maintenance] - [System]
- [Hardware] - [Device Manager].
B Double-click [Intel(R) PRO/Wireless 2915 ABG Network Connection] at [Net-
work Adapters].
C Select [Advanced], and then select [Wireless Mode] in [Property].
D Remove the check mark from [Use default value], and select the settings.
(E.g., [802.11a and 802.11g])
E Select [OK].
Switching of communication under the 802.11a standard between enabled or dis-
enabled using the Wireless LAN Switch also switches the setting of the wireless
LAN standard ([Wireless Mode] in [Device Manager])
Setting in Wireless
LAN Switch
802.11a is enabled
⇔
802.11a is disabled
Setting in Device
Manager
[802.11a , 802.11b
and 802.11g]
⇔
[802.11b and 802.11g]
[802.11a and 802.11g] ⇔ [802.11g only]
[802.11a only] ⇔ [802.11b only]