28
CAUTION
5
Snap the module into place by pushing down on it.
Installing the RAM module
RAM modules are extremely sensitive to static electricity. There are cases where
static electricity generated by the human body has adversely affected such mod-
ules. In addition, it is easy to damage the RAM modules or internal components of
the computer. Therefore, when installing or removing a RAM module, handle the
module with extreme care.
Installing/Removing the RAM Module
2
Removing the RAM module
Open the left and right hooks.
Gently remove the RAM module from the slot.
RAM Module
4
Remove the battery pack ( page 25)
Put the cover back into place, then fasten screws
Power off your computer
( “Starting Up/Shutting Down”)
Do not shut down using the suspend or hibernation mode.
Disconnect the AC adaptor.
1
2
2
Slide in the module at an angle.
RAM Module
2
2
Hooks
Remove the cover
3
Remove the ten screws with a screwdriver, and remove the bottom
cover as shown in the illustration.
RAM module specifications
144 pins, SO-DIMM, 3.3 V, SDRAM, PC133 Compliant
Only a RAM card designed for PC133 can be added
(Max. 512 MB).
Use a RAM module meeting the RAM module specifications below. If a module is used
that does not meet the specifications, there are cases in which data may become unus-
able or the computer may not operate properly.
NOTE
Whether the RAM module is properly recognized or not can be con-
firmed in [Information] of the Setup Utility ( page 40). If the RAM
module is not recognized, power off the computer and reinstall it.
To Next Page
Loading...
