37
External Display
1
Connect the external display to the port replicator
Do not shut down using the standby or hibernation function.
Power off your computer ( "Starting Up/Shutting Down")
Turn on the external display, then turn on your computer
4
You can select either an external display, LCD or simultaneous with Fn
+ F3 .
In addition, you can set the display to use during start-up with the follow-
ing procedure.
For more detailed information, refer to the operation manual of the external
display.
3
NOTE
Run the Setup Utility ( page 51)
Using either or , select [Main]
1
2
3
4
Using either or , select the display to use and press
Enter
Press F10 , then select [Yes]
5
Using either or , select [Display] and press Enter
Connect your computer to the optional port replicator
( The operation manual of the port replicator, page 47)
2
External Display Port
Port Replicator
6 Select your external display
Set your external display for [Monitor] in [Start] - [Settings] - [Control Panel]
- [Display] - [Settings] - [Advanced].
When a monitor that does not conform to the Plug & Play standards is
connected, select [Change]* and make the monitor settings.
* Windows 2000 : [Monitor] - [Properties] - [Driver] - [Update Driver]
Windows 98 Windows 2000
To Next Page
Loading...
