11
TPS Operation (Tape program
Search)
Press [4 TPS] to activate the tape program search mode.
To select a desired program, press [
ii
] or [
jj
] corresponding
times to go backward (up to 8) or forward (up to 9).
(Rewind:) (Fast forward:)
8019
cdcd
Ex1. To select the current program
again, press [4 TPS], and
press [
ii
].
Ex2. To select the previous pro-
gram, press [4 TPS], and
press [
ii
] twice.
Ex3. To select the next program,
press [4 TPS] and press [
jj
].
Ex4. To select the next 3rd pro-
gram , press [4 TPS], and
press [
jj
] three times.
Press [4 TPS] again to cancel.
Notes: The TPS mode may not work correctly in the following
cases. This, however, does not mean that the unit is defective.
●
There is an interval less than 4 seconds or having a high level of
noise or hum between programs.
●
There is particularly low-level passage during the program.
Notes:
●
To maintain your cassette player in top condition, avoid using tapes that are longer than 90
minutes (C-90).
●
If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a
finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette,
make the tape tight, then insert it back into the deck.
d
or
To Next Page
Loading...
