16
Alarm Time Setting
Press and hold [ALM] until you have set the alarm time. "AM
12:00" blinks, and the alarm time setting mode is activated.
Press [
ii
] to set the hour.
Press [
jj
] to set the minutes.
(Hold [
ii
] or [
jj
] to change numbers rapidly.)
When you have set the alarm time, release [ALM].
Note: When the alarm is not set yet, "AM 12:00" is displayed.
Resetting the Alarm Time
When you want to reset the alarm time, repeat steps
to
above.
Alarm Operation
●
Alarm is switched to ON or OFF each time [ALM] is pressed.
●
When the alarm is switched to ON, the alarm sound will activate
at the set alarm time.
Turning off the Alarm Sound
The alarm sound will turn off automatically after 90 seconds.
Otherwise, press [ALM] once.
Cautions:
●
Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving.
●
If the alarm is set, be sure to check the set alarm time by pressing and holding [ALM] for more than 2
seconds.
●
If volume is set at "0" step, the output volume will be muted. (Even when ALARM is acting.)
Clock Basics
(continued)
d
or
Alarm output Volume Selection
You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in
sequence and the display will show as follows.
ALARM TIME
a
ALM VOL 1
a
ALM VOL 2
(display 3 seconds) (display 2 seconds) (display 2 seconds)
OFF
To Next Page
Loading...
