52
Installation Guide
WARNING
Ȏ This installation information is designed for professional installers with knowl-
edge of automobile electrical safety systems and is not intended for non-technical,
do-it-yourself individuals. It does not contain instructions on the electrical installa-
tion and avoidance of potential harm to air bag, anti-theft and ABS braking or other
systems necessary to install this product.
Any attempt to install this product in a motor vehicle by anyone other than a profes-
sional installer could cause damage to the electrical safety system and could result
in serious personal injury or death.
Ȏ&BUKQN?=NEOAMQELLA@SEPD=EN>=C=J@KN=JPEPDABPOUOPAIOOLA?Eł?LNK?A@QNAO
may be required for connection and disconnection of the battery to install this prod-
uct.
Before attempting installation of this electronic component against the manufactur-
er’s recommendation, you must contact your car dealer or manufacturer to determine
the required procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOY-
MENT OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN
DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH.
Overview
This product should be installed by a professional.
However, should you decide to install the product
against the manufacturer’s recommendation, these
operating Instructions do not contain electrical
installation instructions. You must contact your car
dealer or manufacturer for electrical connection in-
structions to avoid possible damage to your electrical
safety systems and resulting injury or death. (Please
refer to the “WARNING” statement above).
Your next step is to decide where to install the
unit. The instructions in these pages will guide you
through the remaining steps:
Identify and label the car wires.
Connect the vehicle wires to the wires of the
power connector.
Install the unit in the dashboard.
Check the operation of the unit.
If you encounter problems, please consult your near-
est professional installer.
Before you begin installation, look for the following
items which are packed with your unit.
Operating Instructions
Installation hardware .....Needed for Installation.
!=OD>K=N@OLA?Eł?=PEKJO
Min. 4.75 mm {
3
/16"}
Max. 5.56 mm {
7
/32"}
Thickness
53 mm {2-
3
/32"}
182 mm {7-
5
/32"}
Warning
This unit operates with a 12 V DC negative !
ground auto battery system only. Do not attempt to
use it with any other system. Doing so could cause
serious damage.
To Next Page
Loading...
