11
ENGLISH
10
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
11
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F.
12
Press to restore the remote control’s default setting.
13
Not used in normal operations.
N
or
OFF
then
press
CANCEL
.
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
SET
.
7
TO ENJOY CLEAN AND FRESH AIR
PATROL/
PATROL
NORMAL
PATROL - To monitor air quality
• Detects air quality; e-ion operation
activates when air quality is at dirty
level.
• Regardless of air quality, to
maintain air freshness e-ion
activates automatically (PATROL
SENSOR indicator turns red) when:
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
- 2 minutes after the unit is on, or
- exceeds 4 hours at clean level.
• Can be activated even when the unit is turned off.
• Patrol starts automatically with the unit switched on with
OFF/ON
.
- To freshen and purify the air
• Generates negative ions to produce fresh air effect and
attract dust which will then be captured at the positively
charged e-ion filters.
• Can be activated even when the unit is turned off. In this
condition, fan speed and air swing can not be adjusted.
8
TO ENJOY QUIET OPERATION
• This operation reduces airflow noise.
9
TO REACH TEMPERATURE
QUICKLY
• This operation will stop automatically after 15 minutes.
To Next Page
Loading...
