67
Security Measure
Wireless LAN uses radio waves to exchange information. Therefore, there is a risk of unauthorized access.
Initialize the app settings on the product prior to disposal or transferring to a third party.
Before setting the network connection
Confirm the wireless router is connected to the network correctly.
Confirm the Wireless LAN of the smartphone is activated.
Confirm your smartphone and this product are connected to the same wireless router.
14.12.2 Connecting Network
Before attempting to connect to the network, ensure the modem or wireless router is working and properly connected
to allow internet access.
Press at the remote control to communicate with the home wireless LAN access point.
Wireless LAN LED from the indoor unit blinks to indicate the connection status to home access point.
Fast blink The unit is establishing the connection.
Slow blink The unit is not securing the connection.
No blink (stays on) The unit has established the connection.
It can establish the connection to the unit even If the unit is turned OFF.
14.12.3 App Installation
For Android user For iOS user
Open .
Open .
Search for “Panasonic Comfort Cloud” app. Search for “Panasonic Comfort Cloud” app.
Download and install. Download and install.
Note
The app user interface image may change for version upgrade without notification.
There is no charge to using this application. However, other charges may be incurred for connection and
operation.
14.12.4 To Disconnect Wireless LAN (Off Wireless LAN LED)
Press and release one time at the Remote Control Wireless LAN button and the LED will turn off. (LED ON ->
LED OFF).
14.12.5 To Delete Wireless LAN Information
If Wireless LAN is off (LED is Off), turn on Wireless LAN first by press and release one time the Wireless LAN
button. (LED OFF -> LED ON).
Push Wireless LAN button for 5 seconds.
In the Remote Control Operation select “5” and push for 3 seconds.
Initialization is finish and Wireless LAN LED will off automatically.
14.12.6 To Check Wireless Lan Signal Strength
Confirm the air conditioner operation is stopped and press the Wireless LAN button for 5 seconds.
Select “4” in the remocon then press set button and operation stops.
After 5 seconds, the signal strength is shown on the indoor unit Wireless LAN LED.
Strong Signal: Blink 3 times with an interval.
Moderate Signal: Blink 2 times with an interval.
Weak Signal: Blink once with an interval.
No Signal: OFF.
It will stop automatically after 10 minutes. To stop immediately, press Wireless LAN button.
GETITON
Google
Play
Download on the
App
Store
To Next Page
Loading...
