122
18.2 Outdoor Electronic Controller Removal Procedure
Caution! When handling electronic controller, be careful of electrostatic discharge.
1. Remove the 5 screws of the Top Plate.
Lift up the left side of Top Plate first then remove
the Top Plate.
Fig. 1
2. Remove the 8 screws of the Front Plate Complete.
Fig. 2
3. Remove the screw of the Terminal Board Cover.
4. Remove the Top Cover of the Control Board by 4
hooks.
Fig. 3
5. Remove the Control Board as follows:
Fig. 4
Fig. 5
Fig. 6
Top Plate
Front Plate Complete
To Next Page
Loading...
