146
18.1.10 Removing the Electronic Controller Box and Bracket
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Remove the screws (1 piece) located at terminal block casing. Then, remove the electronic controller box
and bracket.
Electronic controler box and bracket
Electronic controler box and bracket
Screw
18.1.11 Removing the nanoe Controller Box
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Perform “18.1.10 Removing the Electronic Controller Box and Bracket”.
7 Disconnect 2 connector (white and green).
8 Remove the screw (1 piece) and disengage the tab (1 location) located at nanoe control board.
Screw
Tab
Connector (white & green)
To Next Page
Loading...
