159
18.3.5 Removing the Propeller Fan and Outdoor Motor
1 Perform “17.2.1 Removing the Outer Top Panel and Outer Front Panel”.
2 Disengage 4 tabs of the electrical component cover (the top cover of the control board) (2 locations each on
the right and left sides). Remove the electrical component cover (the top cover of the control board).
3 Remove the fixing screw (1 piece) of the power-supply box.
4 Disconnect the connectors of CN-MTR1 (red) and CN-MTR2 (white) only.
Notes on assembly: When performing the wiring after the replacement of the outdoor motor, close the top
cover of the control board before connecting the connectors of CN-MTR1 & 2 for wiring. If the wiring is
performed without closing the top cover of the control board, the wire may get pinched while closing the
cover.
5 Rotate the nut located in the center of the propeller fan clockwise. Then, remove the propeller fan.
To Next Page
Loading...
