160
6 Loosen the fixing screws (4 pieces) of the outdoor motor and remove the outdoor motor.
Outdoor motor
Screw
4 locations at
every corner
Notes on assembly: When assembling the propeller fan and outdoor motor, the alignment mark located in
the center part of the propeller fan should be aligned with the slit in the shaft of the outdoor motor.
18.3.6 Removing the Outer Side Panel (Right)
1 Perform “17.2.1 Removing the Outer Top Panel and Outer Front Panel”.
2 Perform “17.2.2 Removing the Electrical Component Covers (2 & 3-way valve Cover and Terminal Plate
Cover)”.
3 Disconnect the connector of the indoor/outdoor connection wires (red, white and black) and remove the fixing
screw of the earth wire (green).
4 Remove the screw (2 piece) which fixes the power-supply box to the outer side panel (right).
Earth wire
Earth wire
Fixing screw
Fixing screw of
outer side panel (right)
Connector of the
indoor/outdoor
connection wires
To Next Page
Loading...
