95
4 OPERATION MODE
The total of cumulative operation time of heating, cooling, defrosting, automatic, blower operation that is
being recorded in EEPROM will be notified by number of times of timer LED flash and notification sound.
Cumulative operation time
Number of times of LED flash
and notification sound
Notification sound
No failure memory Existence of failure memory
Less than 3 mins 1
bleep bleep bleep
3 ~ 15 mins 2
15 ~ 30 mins 3
30 mins ~ 1hrs 30mins 4
1hrs 30mins ~ 2hrs 30mins 5
2hrs 30 mins and over 6
EEP memory timing of cumulative operation time of operation modes is changed according to total of
cumulative operation time.
Total of cumulative operation time EEP memory timing
Less than 3 minute Continuous operation for 3 minute and stop operation
Less than 15 minute Continuous operation for 15 minute and stop operation
Less than 30 minute Continuous operation for 30 minute and stop operation
30 minute and over
Stop ⇒ The first time of starting operation : continuous operation for 30 minute and stop operation
More than those above : Continuous operation with 1 hour and stop operation
5 PREFERENCE SETTING MODE
Set mode type
"Beep"
Remote control switch
Emergency SW
Execution check mode
Set remote control No.
"Beep"
Power relay ON
"Beep"
Set electric current Hi
Emergency SW
Set electric current Lo
"Beep"
Remote control No. switch/
execution check mode
Diagnosis code received
"Beep"
Electric current switch mode
Diagnosis code received
"Two Beep"
Not used
Diagnosis code received
"Three Beep"
Not used
Diagnosis code received
"Four Beep"
Not used
Diagnosis code received
"Bleep"
Each mode is cancelled if no operation is performed for 5 minutes or any code other than the
diagnosis code is received from the remote control.
To Next Page
Loading...
