27.7. POINT OF REMOTE CONTROL INSTALLATION
27.7.1. Notes regarding wired remote control unit setting-up location
- Select a place where the remote control unit can be operated easily (after obtaining approval from
the building's owner).
- Install in a place which is away from direct sunlight and as free from humidity as possible.
- Install in a place which is as flat as possible to avoid warping of the remote control unit. (If
installed to a wall with an uneven surface, damage to the LCD case or operation problems may
result.)
- Install in a place where the LCD can be seen easily. If the remote control unit is installed
somewhere which is too low or too high, it may be difficult to read the LCD. (Standard height from
the floor is 1.2 to 1.5 metres.)
240
To Next Page
