30 m of pipe length. This makes installation much easier.
- Drain water dripping-prevention structure
- The base of the outdoor unit is provided with a single drain hole in
order to prevent drain water from leaking out of the unit. By
connecting a drain elbow and a discharge pipe, water leakages
can be prevented even when the unit is installed to a wall.
- Save space design allows units to be installed side-by-side
continuously
- Servicing after installation can be carried out by removing the front
covers.
- Long pipe design for refrigerant pipes
- Maximum piping length of 50m for all models.
- Internal pipe connection
- Pipes are connected inside the units (inside the side covers),
making the final appearance more attractive.
- Pipes can be diverted outward in any of four directions (forward,
right, down, rear).
- Small liquid pipe diameters of 9.52mm for 43BB and 50BB models,
making installation work much easier.
- Centralized draining method
- Even when multiple outdoor units are installed to a wall, the drain
outlets can be concentrated into a single drain pipe. This makes
installation easier and also improves appearance.
6
To Next Page
Loading...
